DERNORD 24V 900W Stainless Steel Heating Element Submersible Water Heater Element
Product Features 24V 900W Element : These elements are made from stainless steel to prevent any corrosion so are suitable for use in virtually all types of water tank Product Application → Great for use heating water in domestic hot water cylinders or water tanks in caravans,boats,workshops etc. Can also be used with waste vegetable
24V 900W Element : These elements are made from stainless steel to prevent any corrosion so are suitable for use in virtually all types of water tank
→ Great for use heating water in domestic hot water cylinders or water tanks in caravans,boats,workshops etc. Can also be used with waste vegetable oil in the the manufacture of biodiesel, and for home brewing etc
→ Can also be used with waste vegetable oil in the the manufacture of biodiesel, and for home brewing etc
→ These can also be used to prevent water freezing during winter months in livestock drinkers or raised ponds by connecting one to a large 24v battery recharged by a large solar panel or wind turbine, just use a basic 5 degrees c normally open thermostat and when the water temperature gets near five degrees the heater will automatically come on and warm the water by a few degrees before switching off again, one could also be used in the water storage tank in your loft if its prone to freezing in the winter months
If you have a gas hot water heater you may wish to put an electric unit ahead of it. This way the gas heater is always being fed hot water so it does not turn on as often and for shorter periods of time when it does.
If used as a diversion (dump) load, such an element is connected to the batteries via a charge regulator. When the regulator detects that the batteries are fully charged, it diverts the generated electricity to the element which heats water.
Product Diameter: 8mm
: Tube length: 7.5 Inch
- 24v DC heater connects with batteries, solar panels, hydroelectric generators and wind turbine dump
- 1″ NPT flange fits USA standard water tank or your own custom heater tank
- UL and cUL listed to the safety standards
- Stainless steel surface has electropolish
- Supplied with silicon sealing washer which is flexible and waterproof
The owner of this website, RDI, is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking 12VoltAppliance.com to Amazon properties including, but not limited to, amazon.com, endless.com, myhabit.com, smallparts.com, or amazonwireless.com. Certain content that appears on this site comes from Amazon Services LLC. This content is provided 'as is' and is subject to change or removal at any time.
Works great in my solar dump load Works great in my solar dump load. On a sunny summer day I can keep a 20 gallon hot water heater hot with my surplus power off my 1.5kw array.
Works Fine Improvised to submerge it in a DIY solar heat reservoir. Works fine. Only thing I am not crazy about is the pair of small terminals on which I needed to connect 8 gauge wires.
Nicely Made I haven’t installed it yet, but I tested it when it came in. It warmed a 1G stainless bowl full of water by 20F in about 30 seconds. It looks well made and there is a nice thick silicone gasket to seal it in the bulkhead. Kudos, Denord!